Removing the Outter Door Panel
1 - Remove Philips the 3 screws from front rubber corner
2 - Disconect the Power Mirror Connector
3 - The mirror can be removed by removing the 2 highlited Nuts (Note, there is an alternate method of removing the mirror, the nuts will be easier to remove if the "Inner Dew Wipe" is removed FIRST, follow the next 3 steps to remove the Inner Dew Wipe.)
4 - Remove all 4 Philips screws from the bracket
5 - Remove the Inner Dew Wipe Bracket
6 - Remove the Inner Dew Wipe (Just pull it up)
7 - The mirror can now be easilly removed by removing the 2 Nuts
8 - Pull the mirror out, be carefull with the Power Mirror wires
9 - Remove the Mirror's outer rubber trim
10 - To Remove the Outter Door Panel, remove the 4 rivets at the bottom of the door
10a - Use a 4 inch nail and a hammer to punch out the center of the rivets
10b - Then you can easily remove the plastic rivet
11 - Remove the 4 Rear Torx screws at the rear of the door
12 - Remove the 3 Front Torx screws at the front of the door
13 - In the door opening where you can see the handdle bracket (from the inside) turn the retainer clip 1/4 of a turn (90 degrees) either way
There is also an alternate method to removing the door skin. Pull the door trim loose from step 24 and use a key to loosen the screw
14 - Pull open the "BOTTOM" of the door panel (sideways), from the rear of the door, unclip the plastic handle arm retainer
15 - Pull the door rod towards the back to remove it, also remove the door lock clip and disconect the rod
16 - Pull the bottom of the door outwards about 10cm (6 inch), push the door panel upwards to "unhook" it at the top